Leave a Reply

Your email address will not be published. Required fields are marked *


  1. Can’t find my operating manual and need to clean the filter and don’t know how to or where to open it to remove it. I have a wall unit

    1. To help you locate and clean the filter in your Frigidaire air conditioner wall unit, please follow these general steps: (General Guideline)

      1. Turn off the air conditioner: Make sure to switch off the air conditioner and unplug it from the power source to ensure safety during the cleaning process.

      2. Locate the air intake: Look for the front panel of your air conditioner unit. The air intake is usually situated behind this panel.

      3. Remove the front panel: Depending on the model, you may need to unscrew or unclip the front panel to access the filter. Look for any screws or tabs that secure the panel and remove them accordingly. Gently pull the panel towards you to detach it from the unit.

      4. Locate and remove the filter: Once the front panel is off, you should be able to see the filter. It is typically a mesh screen or a foam pad. Carefully remove the filter from its housing.

      5. Clean the filter: Rinse the filter with warm water to remove dust, dirt, and debris. If it is a foam filter, use a mild detergent to wash it. Ensure the filter is thoroughly dry before reinserting it into the unit.

      6. Reinstall the filter and front panel: Place the clean and dry filter back into its housing. Then, reattach the front panel by aligning it with the unit and securing it with the screws or tabs.

      7. Power on the air conditioner: Plug in the air conditioner and switch it on. Confirm that the filter is properly installed, and the front panel is securely attached.